Whirlpool 4396710P KitchenAid PUR Push Button Cyst-Reducing, Side-by-Side Refrigerator Water Filter, 2-Pack
Buyer Reviews
I have a Kenmore refrigerator form Sears that I purchased about a year and a half ago. Kenmore is essentially created by Whirlpool and while the filter this replaced was labeled Kenmore, this is the precise similar filter but labeled Whirlpool rather. I looked it up on the Sears web-site and they wanted $50 for the similar filter. The price is a steal and even although it says 6 months I made use of it for more than a year considering the fact that I have soft water in my home and only a single individual. My fridge has a 6 month built in timer that goes from green to orange to red when the 6 months is up. I thought it may possibly be based on actual usage, but it is not, since it went red at exactly 6 months and I use far much less water than most other households. I have no notion why far more time would harm a filter, as far as I am concerned it really is just a promoting tactic to get you to obtain them much more usually then needed, like oil adjustments each and every 3,000 miles.
I purchased my whirlpool refrigerator from sears in 2006. Sears sent me a reminder through mail that I require to replace my filter. I nearly ordered the component by means of the sears.com web page since this distinct filter was not obtainable through the sears retailer or via their parts center. I went to the sears.com site and their cost was $60.59($44.98part+ $four.62tax+$10.99shipping). Then I believed about checking amazon.com to see if this filter was attainable, and it was, for a considerably lower cost to me. My total was $41.98($34.99part+$6.99shipping). I ordered the filter on May30 and received it by way of usps on June2. Replacing the filter was painless - just pop out the old 1, transfer the filter cap from the old filter to the new a single, and pop the new filter assembly back in. The old filter was dripping water, so I took it more than to the sink to shake out the water and out came some rust colored water and small pieces of debris which would have been in my drinking water if it had not been filtered out by the filter. So it is a fine thought to replace the filter on a typical basis.
Product Description
Amazon.com Item Description
Make sure the water and ice from your refrigerator is as clean and fresh tasting as conceivable by replacing its water filter. This Whirlpool PuR water filter is implemented in Whirlpool, KitchenAid, Maytag, Amana, and JennAir side-by-side refrigerators with filter access in the base grille.
It really is NSF-certified to reduce cysts, particulates (class I), asbestos, lead, mercury, and way more. (The contaminants or other substances removed or decreased by this water filter are not necessarily in all users' water.) When it successfully removes contaminants from your water and ice, this filter also lowers the taste and odor of chlorine when retaining advantageous fluoride.
For the highest good quality water and ice, your refrigerator's water filter requirements to be changed over a period of time as its effectiveness at cleaning the water is decreased. For optimal results, you need to replace this refrigerator water filter just about every 6 months to ensure clean, secure drinking water and ice.
Your refrigerator will even remind you when to alter its filter, turning on an indicator light identified near the water dispenser. Modifying the filter is easy--just find the old filter, twist and turn it until it becomes loose, then pull the old filter out and replace with the new filter.
This model (4396710) can be implemented to replace the following water filter model:
- 4396711
Replacing Your Water Filter
For side-by-side refrigerators with filter access in the base grille, comply with these directions for replacing your filter:
- Push the eject button, then pull the filter cap. Do not twist cap.
- Remove the filter cap by turning it counter clockwise. Set aside cap. Discard old filter.
- Get rid of the packaging and O-ring covers from the new filter.
- Align arrows on the cap and new filter. Turn clockwise to snap in location.
- Push filter into the base grill until the eject button pops. Gently tug on cap to assure it is snug.
- Flush the water method till a total of three gallons (12 L) has been dispensed.
From the Manufacturer
This two-pack premium push-button refrigerator water filter is made use of in Whirlpool and KitchenAid side-by-side refrigerators with filter access in the base grille. Basically press the release button to remove and replace the refrigerator water filter. While retaining advantageous fluoride, this NSF-certified refrigerator water filter reduces cysts, asbestos, chlorine taste and odor, particulates (class I), lead, and mercury. The contaminants or other substances removed or decreased by this water filter are not necessarily in all users' water. Replacing this refrigerator water filter each 6 months ensures clean, protected drinking water.
Product Details
- Shipping Weight: 1.6 pounds (View shipping rates and policies)
- Shipping: This item is also available for shipping to select countries outside the U.S.
- ASIN: B001AAEG8G
- Item model number: 4396710P
Technical Details
- NSF-certified refrigerator water filter retains beneficial fluoride in water while reducing chlorine taste and odor
- Also reduces cysts, asbestos, particulates, lead, mercury
- Replace every 6 months
- 2-pack premium push-button refrigerator water filters
- For Whirlpool and KitchenAid side-by-side refrigerators with filter access in the base grille
0 comments:
Post a Comment